Barn find 70 Camaro

[Chadf]

First test fit of the dynacorn floor.. i must say its fits very very well.. the only toe boards i could get were the goodmark 2 piece toe boards and these ones are absolutely horried... lots of hammering and dollying to get them even remotely close... and they still need a ton of tuning up... oh well.. They are stamped in Taiwan so i guess i should know better lol...

 

[Chadf]

It has also become apparent that this car was in a wreck one time and mudded up and fixed with fiberglass matt..... i am really thinking about pulling my 34 ford off my jig table and setting the camaro up... or building a "jig" for the camaro

 

[Bandit723]

Would be a good idea...

 

[Chadf]

Would be a good idea...

Yeah if it hadnt been hit i wouldnt bother.. but it has ...so i will have to do something.

 

[dave@ztech]

With your level of skill , should be no big step and should make your life easier moving forward.

 

[Chadf]

With your level of skill , should be no big step and should make your life easier moving forward.

I just need to find out where exactly all the correct locating holes are and build a locating table

 

[71RSLS]

Here's a link to some specs I found on this site.

http://www.nastyz28.com/tech/framechk.html

 

[Chadf]

71RSLS ... thanks buddy.. that will help out as well !

 

[Chadf]

Did a little tinkering around with the 70 tonight.. the front firewall body mount was rotten.. so i gave it a make over... cut it all out.. made a new peice.. put all the correct notches and bends in it... butt welded it up, gave it a light grind.. then run over it with the sandblaster... gave it a quick squirt with some rust convertor to kill anything that was possibly left just to be safe and then sprayed it with some zinc weldable primer... call it a night....

 

[Chadf]

Onto the other side.. pretty self explanatory...rusty....cut it out...form new peice ......weld....sandblast..weldableprimer toe boards are next......if anyone is following along that is.. lmao