Clay's 70 Re-Progress Thread

[clay's70]

The black mask on the windshield looks good!

Thanks Terry!!

 

[clay's70]

Painted the backside of my wheels.

Sandblasted and painted the driver door window parts.

 

[clay's70]

Went to replace the brake fluid and could not get anything to bleed. My plan was to re-do the brakes
over the Winter. So, I'm replacing all the lines with stainless and replacing the master cylinder and
proportioning valve.

 

[clay's70]

Some progress. Paint dust everywhere

 

[earnhardtgm3]

Coming together nicely. Like the black on windshield as well

 

[clay's70]

Coming together nicely. Like the black on windshield as well

Thank you Victor!!

 

[clay's70]

Progress on the brakes. New stainless lines from In-Line Tube. Flex
line clips 1457--2 (4-pack) from Advanced Auto worked great to replace the old ones. I
still have a few more clamps to install and adjust the hard lines at the prop. valve.
I had to make the gasket that mounts between the plate and the firewall.

 

[clay's70]

Finally was able to finish the brakes, repainted the calipers and got the system bleed. Installed the
door mirrors. Backed Jane out of the garage so I could clean up a little bit. Started on getting the parts back in the doors.

 

[hubedobeedo]

Finally was able to finish the brakes, repainted the calipers and got the system bleed. Installed the
door mirrors. Backed Jane out of the garage so I could clean up a little bit. Started on getting the parts back in the doors.

great progress. looking good!

 

[clay's70]

Wiring for the driver door is run. All parts back in the door except the glass. Mounted
the door lock switch where the window crank goes in the door panel.

The lock switch is out of a Suburban, it's the lock switch that is located by the rear cargo door #15732131 (JUNKYARD PULL)

GRAY = LOCK, WHITE = UNLOCK, ORANGE = GROUND