Separate names with a comma.
Discussion in 'Project Progress' started by Twisted72, Nov 16, 2015.
That is some nice work you are doing.
l got mostly done with welds and everything was looking good ..then..I noticed dents in the quarters both sides same spot (must has got to hot ) got pissed and took a hammer and off to the scrap yard..I was thinking about it, but I grab sander and fiber hair slung the mud to it didn't get pic's cause I was so upset just wanted to get the dents gone ..when I get it body worked I will grab some pic's
Nice work on the window area. Looks very time consuming but will be well worth it. Great job.
well its been a tough one but I think I got the just of it, No it's not done still little more sanding and filling and sanding
Looks good, i like it. Should of fixed the trunk springs before u welded the filler panel in
going with gas shock..thought it thru
well had to go out of town to help my sister and brother ..stayed in Eddyville Ky and was in car heaven 3 garages 15 cars motors, tranny, rearends just laying around ..27 chevy, 49 ford, 68 chevy 327, 78 t/a, 57,55 chevy just a few. going back to hopefully get a few things I need in a month
major score ..Ford 9 inch for 100.00
suppose to came out of a galaxy 500
could some one please measure Camaro rear from out edge of leaf spring to the other. I need to know if I need to relocate the spring mount ..I don't have leaf springs going with a Ride Tec coil over
never mind I found it Camaro 10 bolt is 45 3/8 center to center of the spring perch. the 9 inch is 46 1/2 center to center