perkalators 77 lt build

Discussion in 'Project Progress' started by perkalator, Feb 14, 2015.

  1. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
    Herr is the drivers quarter the first coat of epoxy. Both lower sections were patched on the quarter n the front and back of the wheel well. I have scotch brited the epoxy to remove trash. As soon as i pushed it outside to cure in the 75 degree weather the wind picked up.

    [​IMG]
     
  2. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
    Started blocking the passenger side epoxy with 220. Not mutch body work to do on the top of the quarter
    [​IMG]
     
    Last edited: May 21, 2017
  3. Twisted72

    Twisted72 Veteran Member

    285
    32
    Nov 8, 2015
    New Albany, Indiana
  4. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
    Ok, I guess the passenger side tailight surround has been bumped at some point. It was not quit flush with the tail light. So im gonna add a layer of 20 guage to get it to match the drivers side.
    [​IMG]
     
  5. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
    The process is started.
    [​IMG]
     
  6. 76_TypeLT

    76_TypeLT Veteran Member Lifetime Gold Member

    6,370
    129
    Jul 26, 2008
    Houston, TX
    The car is looking really nice, you are doing it the right way. I really like the underside, wish I would have done that.
     
    perkalator likes this.
  7. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
    Thanks Aaron. I almost changed my mind on the bottom and went with all chassis black. Im glad i went with the raptor for the two tone look.
     
  8. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
  9. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
    Here is the whole back end. I think it looks way better than factory.
    [​IMG]
     
    Codemonkey17 likes this.
  10. perkalator

    perkalator Veteran Member

    937
    56
    Aug 27, 2014
    kennewick wa
    Oxarc and wessco were closed over memorial day weekend. For good reasons. I couldnt get my welding gas bottles exchanged or get some more seam sealer. I only have a few trim holes to weld up on the passenger rocker. I did manage to get the passenger side quarter in epoxy and start laying down seam sealer inside the shell.
    [​IMG]
     
    Codemonkey17 likes this.

Share This Page