My 73

Discussion in 'Camaro Questions' started by Thrust!, Sep 18, 2017.

  1. Thrust!

    Thrust! New Member

    20
    2
    Sep 18, 2017
    I picked her up in January, got a few months of work on her then it sat for a bit. Finally getting the last bit of work done on it, I'm really hoping to be driving by October. Biggest thing I need now is to find the correct driveshaft :)
     

    Attached Files:

  2. CorkyE

    CorkyE Veteran Member Lifetime Gold Member

    8,813
    133
    Nov 4, 2004
    Ringgold, GA
    Looking good. If you haven't already, post a wtb for a driveshaft in the swap meet section, I'm sure someone will have one. I have an extra one in my garage but it's impractical to ship.
     
  3. Thrust!

    Thrust! New Member

    20
    2
    Sep 18, 2017
    I have one, it's just too big. Looking into getting it cut and balanced now.
     
  4. sickfast1964

    sickfast1964 Veteran Member

    421
    5
    Aug 26, 2012
    Corinth, Tx
    Good looking car, Welcome !!
     
  5. Thrust!

    Thrust! New Member

    20
    2
    Sep 18, 2017
    Getting it buffed, waxed, and glazed tonight. I'm hoping its drivable by the weekend.

    Does anyone have any suggestions on plugging aftermarket gauges into the cars wire harness or should I run all new wires?
     

    Attached Files:

    bodymanbill likes this.
  6. BonzoHansen

    BonzoHansen Administrator Lifetime Gold Member

    Nice car. you could treat her to a new driveshaft either from a local place our one of the mail order places like inland Empire or Dennys. you'll have it in a week or so
     
  7. Thrust!

    Thrust! New Member

    20
    2
    Sep 18, 2017
    I picked up a nice solid one from a z-28 recently.
     
    BonzoHansen likes this.

Share This Page