Factory Gauge Harness Connector

Discussion in 'Electrical Systems' started by Orange71, Mar 28, 2009.

  1. phat80

    phat80 Veteran Member

    1,020
    10
    Jan 4, 2013
    Victoria BC
    How can I save this entire thread? Thanks
     
  2. raceangle78

    raceangle78 New Member

    11
    0
    Nov 28, 2017
    florida
    great identification. one note I found was the wiring code is the same on gauge cluster and warning cluster but the position on the connector for the cluster is different. I have a diagram I will try to send you in a next response.
     
  3. raceangle78

    raceangle78 New Member

    11
    0
    Nov 28, 2017
    florida
    hope this helps
     

    Attached Files:

  4. 75Motion

    75Motion Veteran Member

    347
    2
    Jan 26, 2008
    Ohio
    This is a great informational write up. Thank's for sharing. I do have one strange question. Does anyone know where you might be able to obtain a male & female connector so you can make a short harness to go between the old connector and the back of the dash?
     
  5. $ Mike 70 Z-28

    $ Mike 70 Z-28 Veteran Member

    911
    12
    Nov 7, 2002
    New York, NY
    You can solder wires on the existing harness head and make a new plug to go to the gauges

    IMAG0558.jpg

    IMAG0570.jpg

    IMAG0559.jpg
     
  6. badazz81z28

    badazz81z28 Veteran Member

    15,445
    229
    May 4, 2001
    Las Vegas, NV
    I just clipped mine and created a new connector.
     

Share This Page