Ote's Recent Activity

  1. Ote replied to the thread Dash re-assembly help please.

    I didn't hear a lot of positive about their fit and finish when I was restoring my car. Plus a couple of sheet metal screws way cheaper...

    Jun 20, 2018 at 6:54 PM
  2. Ote replied to the thread Dash re-assembly help please.

    A couple of small sheet metal screws from underneath will hold it down. Just don't screw them in too far. You don't want the point...

    Jun 19, 2018 at 5:33 PM
  3. Ote replied to the thread More desktop dyno mooching....

    yep, vac advance hooked to manifold vacuum will get you a whole bunch of idle rpm. And engine vacuum. And better gas mileage, but I...

    Jun 16, 2018 at 7:45 PM
  4. Ote replied to the thread More desktop dyno mooching....

    The cam that we have is fairly aggressive, so ability to idle at low rpm is pretty much out. I think it's a very good cam. It idles...

    Jun 16, 2018 at 7:05 PM
  5. Ote replied to the thread More desktop dyno mooching....

    Because I'm an automatic, my idle requirements will be a little different than yours. I idle at around 1100 in drive. That becomes...

    Jun 16, 2018 at 6:12 PM
  6. Ote attached a file to the thread More desktop dyno mooching....

    I have a 383 similar to yours in my '71 Z. Same Howards cam. Similar ProMaxx 200cc intake, 70cc exhaust aluminum heads (64CC), but...

    Redding Dyno Report.jpg Jun 16, 2018 at 5:27 PM