John Wright's Recent Activity

  1. John Wright replied to the thread Post up your "big wheeled" cars...AKA...17's or larger AND ADD YOUR BACKSPACING INFO!!!!!.

    Off the shelf Cragar Soft 8 BS: 17x8" - 4.5" BS 17x9" - 5" BS I'm thinking about getting a 17x9" - 5.5" BS so I can run the same size...

    Aug 15, 2018 at 3:08 PM
  2. John Wright replied to the thread I am back.

    Dang Hogg, hope you get well soon.....listen to the doc brother

    Aug 15, 2018 at 10:50 AM
  3. John Wright liked MIDNIGHTBLUE's post in the thread I am back.

    Wishing you all the best. I am a type II diabetic. My Metformin's effectiveness began dropping, the doc was talking about injections....

    Aug 15, 2018 at 10:48 AM
  4. John Wright replied to the thread 1970 Camaro - Steering Inner Tie Rod Grease Leak.

    I've picked up my grease gun after it had sit in the heat in my shed and it would drip out all over me if I wasn't watching. It was like...

    Aug 13, 2018 at 2:23 PM
  5. John Wright replied to the thread Looking for stock height spindles.

    Thanks, good catch Scott!....Apologies to the OP. I didn't look at them close enough when I "Googled" them. I thought Classic Industries...

    Aug 13, 2018 at 2:13 PM
  6. John Wright replied to the thread Looking for stock height spindles.

    https://www.summitracing.com/parts/rsd-dbsp01?seid=srese1&cm_mmc=pla-google-_-shopping-_-srese1-_-right-stuff-detailing&gclid=EAIaIQobChM...

    Aug 13, 2018 at 11:29 AM
  7. John Wright liked SR79's post in the thread 79 street/strip/corner carver.

    It's your lucky week! New video from Barber is up (and I'll post it in my update below).

    Aug 11, 2018 at 9:44 AM
  8. John Wright replied to the thread Since all you guys are lawnmow'n yard equipment gurus, help me out..

    Around here Marathon gas stations carry straight gas without any ethanol added, it costs a lot more, but that's what I use now in all of...

    Aug 11, 2018 at 9:41 AM
  9. John Wright replied to the thread Understanding Lift Specifications.

    If you have options, get the most ceiling height possible, even if you have to lay a few courses of CMU and then build on that to get...

    Aug 9, 2018 at 2:48 PM