Goat's Recent Activity

  1. Goat replied to the thread block clearancing for rotating assembly.

    The only other thing I would suggest is to clearance the block before boring the cylinders if possible in case the tool jumps and nicks...

    Nov 19, 2017 at 8:29 AM
  2. Goat replied to the thread Acceptable 9" noise.

    I guess I would have to hear the noise. Mine doesn't make any noise that I would consider unusual, but everyone's ear is different... I...

    Nov 18, 2017 at 3:38 PM
  3. Goat replied to the thread block clearancing for rotating assembly.

    I did. Wasn't too bad and that was a 3.875 stroke. Just takes patience - wait, that might be a problem for you!:crazy: I have a set of...

    Nov 18, 2017 at 3:33 PM
  4. Goat replied to the thread block clearancing for rotating assembly.

    What will the piston bore size be?

    Nov 17, 2017 at 4:06 PM
  5. Goat replied to the thread Driveline Angle and Pinion Angle.

    You have a 4 link right? How easy is it to adjust? I would get an angle finder and adjust the rear down two degrees and see how it...

    Nov 14, 2017 at 7:50 AM
  6. Goat replied to the thread Driveline Angle and Pinion Angle.

    I used to be confused about this too, until I did a lot of research. As SRGN points out, these "ideal" pinion angles you read about are...

    Nov 13, 2017