Separate names with a comma.
ok great...thank you so much..Jim
It's OER. So does the tan insulator go on first? Next to metal plate? Then studs through plate, circuit board, nuts?
Anyone? Just need to know the order of re-assembly.
Finally getting around to install gauges again. I needed to replace fuel gauge, but don't remember the order of parts to reassemble it. (It's only...
Too bad it was a great place for members to meet one another. Jim
My gauge is in exactly the same place as Hornet's picture, never moves no matter what I do to it.
Same problem here. I tried everything beindog did, no change. What's next? BTW also replaced sender
Thank you Dave....and everyone else, very helpful. Jim
Thanks guys, but seems like there's a few numbers being put out there, not sure which one is correct? jim
Could someone give me the correct part number for fuel pump in 72 Z-28? 2nd week of dec 71 car. I tried a search, but can't find it. Thank you Jim
I don't blame you. Been looking for a drivers rear set for over 10 yrs. A member here found a belt for me. Was able to buy a buckle for retractor...