Separate names with a comma.
I have a bunch of tip kits for sata guns. You are correct you have to change the cap and needle at the same time
A buddy told me it's due to I need to thin it more. So I thinned it and bam that was the issue. It was just a little too thick
I did run thinner through the gun before I used it to clean it and it was broke down and cleaned good before I ever put my material in it.
I am using a sata 3000 hvlp and it's new never used the paint was bought Friday. I have tried 20 through 40psi. It is nason sealer for the inside...
i can't get my paint gun to not splatter my sealer. It mixes 4 to 1. Let me know if you know why it splatters and not lay down flat? The...
I have had my homelite with a Subaru motor on it since 1998 and never had to work on it other than plug and oil changes along with air filter....
I am just outside of Savannah Georgia and they say we won't have power for about 4 to 7 days
We are starting to get a little of it now.
I am looking for a edelbrock but open to anything at this point. It's going on a 300ish hp motor for a daily driver
My next truck without a doubt will be a diesel
My ram 1500 around town gets 22-24 and 27 on the hwy and I have gotten as much as 30 on a trip going 70 mph