|
06-11-2009, 01:31:39 AM
|
#1 |
|
Veteran Member
Join Date: May 2004
Location: Michiana
Posts: 792
|
Bellhousing/flywheel size question
I have a factory aluminum "621" bellhousing & was wondering what size flywheel ? I believe I heard an 11 inch fits.
__________________
www.peelracing.com Hey, you want to lay the fate of the world on the kid's Camaro? That's cool. |
|
|
|
06-11-2009, 01:33:26 AM
|
#2 |
|
Lifetime Gold Member
Join Date: Feb 2002
Location: Warner Robins, Ga
Posts: 1,490
|
Need the 168 tooth Flywheel
__________________
Steve 1970 Z28 350 LT1 342 with M-20 "Cranberry" Red with Black Stripes 
|
|
|
|
| Messages from Our Sponsors ! | |||
|
|
|
|
06-11-2009, 01:57:10 AM
|
#3 | |
|
Veteran Member
Join Date: May 2004
Location: Michiana
Posts: 792
|
Quote:
__________________
www.peelracing.com Hey, you want to lay the fate of the world on the kid's Camaro? That's cool. |
|
|
|
|
|
06-11-2009, 02:16:50 AM
|
#4 |
|
Lifetime Gold Member
Join Date: Feb 2002
Location: Warner Robins, Ga
Posts: 1,490
|
Yes 11 inch with 168 tooth flywheel
__________________
Steve 1970 Z28 350 LT1 342 with M-20 "Cranberry" Red with Black Stripes
|
|
|
|
|
06-11-2009, 08:39:57 AM
|
#5 |
|
Veteran Member
Join Date: Oct 2003
Location: malaga, nj
Posts: 1,392
|
The 11 inches you refer to is the diameter of the clutch disk, not the flywheel. As stated, you will want one with 168 teeth. the clutch setup you choose will depend on what the flywheel is drilled for. some are for the 11 inch, some for the 10.4 inch and others have a dual pattern. If you have a choice, go for the one that will allow you to use the 11 inch clutch. It will be stronger and last longer. Good luck.
__________________
Pat -- I feel like I am in the "Planet of the Apes" and the apes are in charge. Have another banana, Barry! |
|
|
|
|
06-11-2009, 07:11:01 PM
|
#6 |
|
Veteran Member
Join Date: May 2004
Location: Michiana
Posts: 792
|
Thanks everyone.
__________________
www.peelracing.com Hey, you want to lay the fate of the world on the kid's Camaro? That's cool. |
|
|
|
|
06-11-2009, 10:03:36 PM
|
#7 |
|
BANNED
Join Date: Jul 2001
Location: Columbia, MO, USA
Posts: 10,512
|
You will probably also need a correct cast-iron snout, staggered bolt starter too!
pdq67 |
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | Rate This Thread |
|
|
Linear Mode
