06-10-2007, 05:11:38 PM
Does anybody know of a manufacturer that can make harmonic balancers with undersized crank hubs? I have an eagle crank that was machined a little too small, and the balancer I was going to use doesn't provide enough interference fit. I need one that is about .001-.002" under.
06-10-2007, 10:53:21 PM
ATI s are known for being on the small side.
06-10-2007, 11:27:40 PM
Like twg says, ATI's usually have to be honed to fit, they are intentionally under sized. Another solution is that you can buy sleeves in various thicknesses.
06-10-2007, 11:58:49 PM
Those sleeves are only for when the timing cover seal wears a groove in the outside of the balancer hub, aren't they?