Ok, here we go...

I have a 350 small block in my 70RS. (bolting or makng holes in the firewall is not an option, so bare this in mind).
I have an edelbrock Victor Jr. Highrise manifold, with a 750 Dbl pumper.

My dilema is that the Victor Jr. has 2 screw holes, and I need to mount my accelerator cable bracket (which I am still looking for) AND the bracket which holds the distributor coil.

Anyone have something similar already set-up?

Any ideas would be greatly appreciated.

Steve

Just get a bracket that bolts to the 2 rear carb bolts for the accelerator cable. Jegs, Summit etc. sell them, that way those other 2 bolt holes are for the coil bracket.

------------------
If all else fails...Tap lightly with a 5lb hammer!