Instructions for the headers state I have to pull the starter? Why?

Usually it's for clearance, you can't always fit the headers in without removing the starter. But than can depend on the exact make & model of headers.

Depends on the starter too. If you are using one of new nifty mini starters you may be able to leave it in place. Who knows, maybe the headers will clear with the stock starter there. Many times instructions are generic in nature.

If you have to yank the starter then disconnect the battery first, assuming your hot battery cable goes to the starter mounted solenoid (as per stock).

I didnt have to pull my starter on my 80. Im using dynomax headers for sbc

[This message has been edited by MulletMan1980 (edited April 27, 2005).]