i mixed up my fuel\air mixture screws, whats a good way to set the screws on my car, its a 600cfm edelbrock performer 4bbl. and also the idle screw on the right side where the throtle linkage is hooked up has been messed with (the one that can rev it up) what should that be at.

thanks guys

The mixture screws are about the same as a Holley- turn all the way in & gently seat them, then out about 1.5 turns. What your going for is the highest RPM while adjusting these.

------------------
11.74/118mph, thats all..

ah, so turn the into the right all the way, turn them out about 1.5 turns and tweak them until i get the highest rpm like 8ish on my rpm gauge. how about the other little screw that controls the throttle that was messed with ?