|
View Full Version : Cam bearing tool slow80sc 02-10-2007, 10:29:35 AM Can somebody give me a good idea on the proper use of a cam bearing tool? I just purchased one and it looks like you drive them in with a 5 lb. sledge. I have apparently never used one. Thanks! rustbucket79 02-10-2007, 11:57:07 AM If you do a search on this forum you will find lots of info on how to install cam bearings, small blocks are about the easiest to do and be successful. GoldenOne7710 02-10-2007, 11:57:35 AM Which one did you buy? Did it come with a long rod or is it just a small round metal biscuit with a hole in the middle? Can you post a pic? Typically a hammer is used. I've seen some more fancy ones that used a slide hammer type of device. slow80sc 02-10-2007, 02:55:27 PM It's just like this one... http://cgi.ebay.com/ebaymotors/NR-Cam-Bearing-Driver-Tool-Chevy-Chevrolet-sb-sbc_W0QQcmdZViewItemQQcategoryZ33614QQihZ008QQitemZ180082272320QQrdZ1QQsspagenameZWDVW |
