Have any of you used one? Are they better than the stupid original? How easy are they to put in?

Thanks

Mines been in for over five years with no problems.They're easy to install and are far superior to the originals.

I have one and I think it's ok- but if I was looking for a new shifter right now- I think I'd look into the Hurst DualGate/2 (assuming this is going on a 3-speed auto, not an OD conversion).

I have a B&M Pro Stick mounted in the console. I just fabbed a cover plate from a piece of flat black plastic. It looks good and works a lot better than the stock shifter.

I have a B&M Megashifter in a stock 70 console and I love it..of course I had no choice..Me car did not come with a shifter at all http://www.nastyz28.com/ubb/frown.gif

http://community.webshots.com/user/95red1

------------------
70 Camaro
Y2K 17" Vette Rims
357ci, 10.5 to 1, 200cc Dart Heads, Roller Rockers, CSI Electric Water Pump, Gear Drive, Demon Carb, Etc. Should be fun http://www.nastyz28.com/ubb/smile.gif
http://community.webshots.com/user/95red1

[This message has been edited by Blue70 (edited December 04, 2003).]

I just installed a B&M console Quicksilver shifter yesterday. I couldnt believe how easy it was. Used the stock cable and brackets on the tranny. Dont have to worry about wiring ang adjusting the nuetral safety switch. It is soooo much nicer than the stock one IMO.

------------------
1981Z28
355, 11:1, 215cc Iron Eagles, 3500 stall, 284 XE cam, Vic JR intake, 750 D.P., CSI waterpump,NOS Cheater System, 3" X-pipe w/ Spintech mufflers
12.32 @ 110 n/a
11.39 @ 117 N20