Hey all. I got my dash pad and under dash pieces installed tonight. however the top of the dash on the passenger side is loose. the dash was not in the car when i bought it so i am not sure if i might be missing some scress. i have all screws in that hold the lower dash/glove box installed. all the clips that slide in the the metal of the dash are in and tight. there are some screw holes though that i have no screws in. these holes are on the metal piece of the dash board on the passengers side and are in between the little clip that bolt to the dash pad and slip up underneath the metal part. do screws go into those holes and up in to the bottom of the dash? thanks lemanster


one more question. the vent in the metal part between the two defrost vents, there is no mounting tabs underneath. did some of these cars not have speaker or anything there, just left open to look down and see all ones wires and such behing the dash. could i cover this opening with something? dont need speakers there so i dont need anything else to go there. any ideas. thanks again. lemanster

[This message has been edited by 67lemanster (edited November 25, 2003).]