just bought a console glove box liner,and does anyone know how the release button gose on the lid...i have the button.spring,and this small clip..does anyone have pictures of this.its on a 1978z28.thanks.

Luis try going to this site. it is a chilton online manual. I dont know if it will give you the detail you need, but it might.

http://www.cybrrpartspro.com/Manual%20Lookup/cal_ModelLookup.html

i see the spring and button,is the spring for the button to retract in and out,if it is where does it go on the lid?

my console is different but i will try and give you my two cents in help. which spring, there is # 20 and #22. i am not familar with the 20 spring but it looks like it would pop up the console alittle when you push the button the aid in opening. the other spring i am somewhat familar with that is the one that holds the lid up once opened. that spring fits on the under side of the box and one end attaches to (hooks onto) the console arm. the other side i believe rests against the console box from the underneath. the box acts as a stop. and once the lid is opened i release tension on the spring and the box stays open. thats about all i know hope this helps.

[This message has been edited by 67lemanster (edited November 21, 2003).]