I need to know the part #'s for the deep groove pulley's for my 70 z28. the numbers in the assembly manual dont seem right

DM,

Here are a couple.

1969-1974 Z28 Crank Pulley was the same except for the 1973 & 1974 models that had AC. 3956668 CG (available in a reproduction from D&R)

Here is the # for a 1971 Z28 Water Pump Pulley which may be the same as 1970 3995647 AP.

The Alternator Pulley is a Deep Groove however it has no numbers on it.

I do not have the Power Steering Pump Pulley info available right now. I will have to dig for that later on today.

Hope this helps,

Bob R

This might help.....

http://www.nastyz28.com/ubb/Forum13/HTML/000458.html

That is the correct WP number for '70

p/s pulley is 3941105 Its not really clear in the book.I need one of these too so I'm not able to look at it to check. 3932458 should be A.I.R. pulley, of which I need one also. I have extras of the crank and w.p. pulleys you need.(668 and 647)

[This message has been edited by 70CitrusZ (edited October 25, 2002).]

[This message has been edited by 70CitrusZ (edited October 25, 2002).]