|
View Full Version : Need a specific height rscamaro73 07-23-2003, 10:13:00 PM Does anyone have the measurments of the typical SBC lifter bore ? Like depth and the width ? I don't have anything accurate enough (here right now) to measure this motor I have apart right now. http://www.nastyz28.com/ubb/smile.gif 1978LT 07-24-2003, 05:36:00 AM .842 diameter and 1.400 long. Thats on an 010 4 bolt block dated 1977. Lowend 07-24-2003, 05:56:00 AM that is pretty typical some lifter bores are a little bigger; .843, but not much more rscamaro73 07-24-2003, 10:06:00 AM Good deal. Thanks. That's gonna be my 'terminal measurement'. If I can't work with it, I'm shafted. http://www.nastyz28.com/ubb/smile.gif rscamaro73 07-25-2003, 07:42:00 AM Anyone have a diameter and length of an LT-1 stock roller lifter ?? Brett ?? http://www.nastyz28.com/ubb/wink.gif rscamaro73 07-25-2003, 09:43:00 PM BETTER YET - I need the lifter bore size for a LT-1 motor (stock roller motor). 1978LT 07-25-2003, 10:59:00 PM Almost positive it is also .842 like the flat tappet motors, and the L98. |