Hey guys, I made a post to see if there was any kind of electrical wire conditioner to make it less brittle. Well.. my wires seem to not be SOOO bad after all, but my question NOW is.. what is the best chemical or solution to use to clean the ends of my wiring harnesses that aren't covered by the GM electrical tape? Any wires that are going to be in the engine compartment should be complete clean!

Thanks,

------------------
Todd,
1997 Pontiac GrandAm SE TwinCam
1987 Pontiac Fiero SE / V6
1984 Pontiac Fiero 2m4 SE
1981 Pontiac TransAm (w/350sbc)

I have used GO-JO to clean the wires and it works great. Go the extra and remove the old tape too, clean, and retape. It will look so much better when your through. And, it's not that much work.

I used wax & grease remover. The stuff you buy at an auto parts store or body shop. It doesn't leave behind any residue and strips off the gunk lefy behind from electrical tape

------------------
*355; World S/R Torquer 2.02" 67cc heads; Speed Pro hyper's @ 9.3:1 CR; CompCams XE262H cam; Weiand Action Plus intake; stock Q-Jet; Pertronics HEI
*B.W. Super T-10 4 speed w/ Hurst Competition Plus shifter & 3.08 posi
*2.5" Flowmaster American Thunder exhaust with Jet Hot coated Hooker Competitions

Thanks Mitch, I'll try that!

Todd