so among some of the modifications im doing to my 71 is putting in a 4th gen t/a dash. since im not going to use the PCM or BCM i need to make new gauges i am modifying the original cluster to suit my needs. Eventually i will be using 3 3/8" autometer sport comp speedo and 2 1/16" fuel, water temp, oil pressure and voltage gauges.

i put some captions on the images, but its just way too many to upload onto here so go check it out

http://rides.webshots.com/album/574962485CjFdJF

I see 4 holes.....

So I'm guessing the Speedo is dead center with no tach ??
Looks interesting. Keep us posted. :bowtie:

http://inlinethumb28.webshots.com/44699/2102307860063542046S600x600Q85.jpg (http://rides.webshots.com/photo/2102307860063542046KagPim)

yea i dont have a hole saw for the speedo. i have a hole drilled for dead center of that gauge. since im going to run an auto i wont need a tach...i tried every configuration i could and i couldnt get all six gauges in there. the faint black outline is the actual gauge pod outline once the cover is snapped on. the 2 1/16 actually measured 2.030 so i could used a 2" hole saw. i need to get a gauge so i can measure it to figure out how big to drill the holes.

ok so heres what ive got today this is basically what it will look like. need to do some finishing touches and get everything sealed and painted. and gauges installed obviously
http://inlinethumb16.webshots.com/6543/2344882610063542046S500x500Q85.jpg