Does anyone sell them? And don't tell me Classic Industries - they advertise them, but they don't have them!

Ireland?? Thats like far away isnt it?? Anyway nice looking car!!! But to the point I bought mine from a place here in Toronto Canada called "EARLY BIRDS" the address is
4256 Chesswood Drive
Downsview Ont. based on my order form from 1999. Paid $90 cdn and they even had the holes drilled for the spot welds!!!
Looking through my business card book Ive found one with a different address??
so here it is.
EARLY BIRDS
Mario Velho Parts Manager
tel: (416)630-8792 fax: (416)630-8794
toll free 1-800-463-0546
www.early-birds.com (http://www.early-birds.com) E:service@early-birds.com
130 St. Regis Crescent, North, Toronto, ON M3J 1Z3
hope this helps

If you mean the 'outer wheelhouse; section - the part that is 'connected' to the rear fender (they share the inner lip that everyone rolls under for more tire clearance)....then I have a set that I'll make a good deal for you. L and R sides.

Drop me an email if this is what you're looking for.....

Part # 1667556 & 1667555 from Classic Industries. pg 479 on their online body section of their catalog.

------------------
" Come to the Dark Side....the BBC force is STRONG within us all...."

73 LT 454 and a small touch of giggles....hee hee hee. More good parts are lining up the shelves.....
mailto:rscamaro73@nastyz28.comrscamaro73@nastyz28.com</A>

http://www.cardomain.com/id/rscamaro73

84 4x4 Suburban 'rust bucket'

http://www.goodmarkindustries.com/HomePage.html

scroll down towards bottom


[This message has been edited by SUPERSONICBLUE70 (edited October 21, 2003).]

Scott: Thanks, man. Actually, the car is in Seattle. Northern Ireland is just where I'm going to school at the moment.

Does early-birds have an online catalog (catalogue http://www.nastyz28.com/ubb/smile.gif )?

Wayne: Nope, Inner.

Like part numbers 1667196 and 1667197 on page 483 of the 2003 Classic Industries catalog.

http://www.rcboat.com/Brian's%20stuff/inner%20wheelhouse%20panels.jpg

supersonic: Sorry, but I'm not following you. I go to that site, but I don't see anything about inner wheelhouse panels?


[This message has been edited by Brian Callahan (edited October 22, 2003).]

So, am I SOL on this one?

If you're still looking...I couldn't find any for my 70 either..so I called up "The Paddock" and they had them in staock. Not the highest quality perhaps, but they fit real nice and fit pretty snug with the new quesrters that I bought.

Mike,

True? I'll check them out. Thanks again!